![]() A typical mixture would contain the following ratios of product:įor difficult to clean inks and/or for water resistant emulsions, use less water. 508 Stencil Removerįor Plastisol and/or UV inks, begin with 5 gallons of water for each gallon of 508. There should generally be two gallons of 808 for each gallon of 508. General Instructions: Determine the capacity of the tank and calculate the required amounts of water, KIWOCLEAN AQ 808 INK WASH concentrate (808) and KIWOCLEAN AQ 508 STENCIL REMOVER concentrate (508). If not all emulsion is removed, a second reclaiming cycle should be used to completely remove the emulsion. This can lead to a hardening of the emulsion and the resulting emulsion residues will be extremely difficult to remove.įor automatic equipment a dwell time of 60 -120 seconds after applying the de-coating solution is sufficient. Rather, rinse the screen and reapply fresh KIWOCLEAN AQ 508 STENCIL REMOVER concentrate.Įnsure that the KIWOCLEAN AQ 508 STENCIL REMOVER concentrate solution does not dry on the screen. Prolonged reaction time may result in reverse effects and does not help in the de-coating process. ![]() A high pressure water spray (1000 - 2000 psi, 40 - 60 bar) may be required for highly water resistant emulsions. Rub the screen gently with a brush to dissolve the emulsion.Īfter approximately 2 minutes, rinse thoroughly with a strong water spray. 508 Stencil RemoverĪpply the diluted KIWOCLEAN AQ 508 STENCIL REMOVER concentrate solution with a soft, clean brush evenly on both sides of the screen after the screen has been carefully cleaned of ink residue. It can also be used in combination with KIWO water based screen cleaners, e.g.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |